|
|
|
|
|
|
|
|
Built on the foundation of the Com-Tech series, Crown's CTs Series offers new flexibility and value for installed sound applications. The Com-Tech Series were the first to offer independent selection of high- and low-impedance operation for a specific channel, and CTs Series amplifiers continue that tradition, with power levels and features carefully chosen to perfectly integrate into fixed install design requirements.
|
Performance
Frequency Response (at 1 watt, 20Hz - 20 kHz) ±0.5 dB
Phase Response (at 1 watt, 10Hz - 20 kHz) ±35°
Signal to Noise Ratio below rated power (20 Hz to 20 kHz) 100 dB un-weighted
Total Harmonic Distortion (THD) at 1 watt, from 20 Hz to 20 kHz <0.05% (typical)
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1, from 163 milliwatts to full bandwidth power <0.05%
Damping Factor 10 Hz to 400 Hz >180
Crosstalk (below rated power, 20 Hz to 1 kHz) >80 dB
Common Mode Rejection (CMR) (20 Hz to 1 kHz) >50 dB
DC Output Offset (Shorted input) <5 mV
Input Impedance nominally balanced, nominally unbalanced 20 k ohms, 10 k ohms
Maximum Input Level (before input compression) +20 dBu
Load Impedance (Note: Safe with all types of loads) -Stereo 2, 4, 8 and 25 ohms (70V) -Bridge Mono 4, 8, 16 and 50 ohms (100V)
Voltage Gain (at maximum level setting), 1.4V sensitivity -4/8 Ohm Operation --20:1 (26 dB) -70V Operation --50:1 (34 dB) -100V Operation --71.4:1 (37 dB)
Required AC Mains 120V 60 Hz, 220/230/240V/50 Hz
Power Draw at Idle (120VAC mains) -All channels in 4/8 ohm mode --70W Cooling Variable-speed forced air
Dimensions -Width, 19 in. (48.3 cm.) -Height, 3.5 in. (8.9 cm.) -Depth 16.25 in. (41.3 cm.)
Net Weight 27 lb, 8 oz (12.5 kg)
|
|